Thingiverse
Stackable Tray Box with Dividers
von Dolyfin
572
Downloads
1.7k
Likes
1
Makes
Heavily inspired by previous designs of the stackable boxes. Check Remixes
This hastily modeled version is a bit bigger with slightly thicker walls to better fit inside my Ikea Alex draws. It also has flat lips on 3 sides (similar to v4/v5) to prevent tilting from stacking many on top of each other. This includes if your print quality is poor and has warped corners..
Walls are 3 layers thick in most areas with some 5 layer thick areas to reduce flexibility.
Provided are 0, 1 and 2 divider versions for various sized parts.
970 x 550 x 1280 mm
Brim recommended to prevent warping.
2 walls minimum, 5 recommended.
Designed with 0.4mm nozzle and 0.2mm print height. No supports should be needed.
2 can fit on my ender 3 v2 with a tiny brim. However the print time and materials used are much higher than v4/v5.
This hastily modeled version is a bit bigger with slightly thicker walls to better fit inside my Ikea Alex draws. It also has flat lips on 3 sides (similar to v4/v5) to prevent tilting from stacking many on top of each other. This includes if your print quality is poor and has warped corners..
Walls are 3 layers thick in most areas with some 5 layer thick areas to reduce flexibility.
Provided are 0, 1 and 2 divider versions for various sized parts.
970 x 550 x 1280 mm
Brim recommended to prevent warping.
2 walls minimum, 5 recommended.
Designed with 0.4mm nozzle and 0.2mm print height. No supports should be needed.
2 can fit on my ender 3 v2 with a tiny brim. However the print time and materials used are much higher than v4/v5.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
