Stacking, Scalable Storage Bins, No Support needed

I designed these after other models either required supports or were not quite what I was looking for. They are easily scalable in any slicer to suite your needs. I use high speed PETG and the standard size prints in 3hr 43min on my p1s. High speed PLA would print in about the same. It uses 169g filament at 0.2mm layer height with 2 walls and 8% gyroid infill. I dimensioned them to be comfortable for me to fit my entire hand in. The interior dimensions of the standard bin are 3.75" wide by 6.73" deep by 4.21" tall. (95mm x 171mm x 107mm) When I scale them I emboss the scale parameters (x, y, z) into the bin itself in the event I ever need to reprint something of the same size. They stack well and have there is an alignment notch to keep stacked bins from sliding off the lower bins. There is an elevated area for a sticker label on the front. For labeling, I am using a DYMO thermal labeler