Stadia Controller Clip

I took the time to trace the contours of the Stadia controller and create a clip out of it. It took about 15 test prints to get the contours just right (not all are pictured). Here I am sharing the STL and Fusion 360 files for derivation.

If you're looking for a phone holder, check out the [Parameterized Stadia Controller Phone Holder](https://www.thingiverse.com/thing:4003544), which is derived from this clip.

Tested in PLA and TPU - TPU was way too flexible, PLA works well but can snap if you're not careful putting it on and taking it off (optional: add a modifier in the slicer to put 100% infill around the USB connection for strength, since that's the place it's likely to break at)