Thingiverse
Stair Post Shelf
von alloria
1
Downloads
1
Likes
0
Makes
Do you have a post that you would like to put a shelf on? You don't? Never mind then.
You probably will once you see my Stair Post Shelf!
The set contains screws to attach the shelf to the post, simply print out four of them. Two different sizes are provided.
The shelf in the picture was printed in PLA at 0.2mm, and the screws at 0.01mm. Beware that the screws are very tight the first time you try to use them, I had to use pliers to loosen them a bit.
You probably will once you see my Stair Post Shelf!
The set contains screws to attach the shelf to the post, simply print out four of them. Two different sizes are provided.
The shelf in the picture was printed in PLA at 0.2mm, and the screws at 0.01mm. Beware that the screws are very tight the first time you try to use them, I had to use pliers to loosen them a bit.
alloria veröffentlicht auch auf
29 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!