Staircase Lighting 45 degrees

A complete led armature for underneath your steps that allows you to use 5mm led strip (or resize in your slicer) and tuck the cable away behind the risers. Just print them as is. In the photo the body is black and the diffuser is white, this works perfectly for no light bleed. Recommended printing settings using a Kobra S1: Body:0.08mm layer height, standing up (this can take a very long time to print). Also make sure you add supports for the hole, i used tree supports. Endcap: 0.08mm layer height Diffuser: 0.12mm layer height For the endcap It's a tight, really tight fit, once it's in you will not get it out without destroying the armature. I used a hammer to get them in ;) To mount Us double sided tape, but please stay away from the AliExpress cheapo's. If you run your led strips at 100% for a while they radiate a bit of warmth and the cheapo tape comes loose. Can recommend 3M For my setup i used (no affiliates, just an impression :) ): 24v Led Strip https://amzn.eu/d/0exalilS Cable https://amzn.eu/d/0eldmoSz Zigbee Controller: https://amzn.eu/d/05a5TXB0 White PLA for diffuser: https://amzn.eu/d/044mb2Hg Black PLA for the body: https://amzn.eu/d/09wsuFVm