Thingiverse
Stamp Holder
by legochuck
0
Downloads
0
Likes
0
Makes
Small compartment for a scavenger hunt designed to hold a small rubber stamp outside.
The lid uses two #4 1/2" flat head screws as a hinge.
The design aims to reduce the amount of water or other debris that can get inside while still allowing easy access via the front swinging door. Includes drainage holes in the bottom, two passthrough holes in the back for use with zip ties, and an inset slot in the lid for laminated signage to be displayed.
The lid uses two #4 1/2" flat head screws as a hinge.
The design aims to reduce the amount of water or other debris that can get inside while still allowing easy access via the front swinging door. Includes drainage holes in the bottom, two passthrough holes in the back for use with zip ties, and an inset slot in the lid for laminated signage to be displayed.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
