Stand-alone MKS Sbase case

Stand alone case for MKS SBase and various displays. Includes space for smoother boards and bed MOSFETs. This is a LARGE case, 177X172 mm. Make sure you can fit it on your bed before attempting to print it.

This case is stable enough to stand beside the printer, or, as with Denos' case, can be mounted to an extrusion via screw holes on the the un-vented side

M3 screws should be used to secure the top to the bottom. All other holes are M4-sized

All versions use the same bottom, a slightly modified version of Denos' case. Multiple tops are available, only one is needed.

Modifications to Denos' case are as follows:

1. Screw holes in the bottom of the case have been extended through the bottom of the case and widened slightly. They now fit M4 screws better, and you can use longer screws without "popping" the stand-offs off of the board.

2. A large round hole has been added to the rear of the case to allow the use of a 3/4" Split wire loom such as the following as s