Thingiverse
Gadgets
Go to Model
Stand for Apple Pencil
201
Downloads
169
Likes
2
Makes
Stand for Apple Pencil
This is a simple stand I created for my Apple Pencil.
It has a small tray in the front for the charge adapter and spare tips.
The prototype was printed without support using PLA+ and 100 micron layer thickness.
I would recommend 30% - 50% infill.
Adding three 3M® BumpOn feet will keep it form sliding around if you have that issue. I got some clear ones to use for this.
This is a simple stand I created for my Apple Pencil.
It has a small tray in the front for the charge adapter and spare tips.
The prototype was printed without support using PLA+ and 100 micron layer thickness.
I would recommend 30% - 50% infill.
Adding three 3M® BumpOn feet will keep it form sliding around if you have that issue. I got some clear ones to use for this.
Festus440 also publishes on
3 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
