Thingiverse
Standard Servo Pan/Tilt Bracket
por POT82ES
3
Descargas
3
Likes
0
Makes
Simple and minimal bracket for connecting two standard sized servos in a pan/tilt configuration. Great for testing without spending too much material.
Should be a tight fit, tested on HiTEC HS-625MG servos. I recommend using M2 or similar sized screws with washers. Minimum amount of screws required is 4, optimally 8.
N.B. You have to print 2 pieces.
Should be a tight fit, tested on HiTEC HS-625MG servos. I recommend using M2 or similar sized screws with washers. Minimum amount of screws required is 4, optimally 8.
N.B. You have to print 2 pieces.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
