Thingiverse

Stanley Razor Scraper

by Evan_VW

1.3k Downloads

886 Likes

38 Makes

Go to Model

A holder designed for Stanley razor blades to help remove 3D prints from the bed. You may also find use in removing decals, cleaning flat glass, etc. There are recesses for the blade to sit and to insert M3 nuts on the back side. Requires 2x M3 nuts and bolts. In the images I used M3 x 4mm which allow the shafts to sit flush on the back of the scraper, so use 4mm length if you have them.

Pictured is the "Punched mini" scraper. For best results, orient the part so that the holes for the m3 nuts are facing down towards the print bed. Support material shouldn't be needed.

Please be careful when using, understand that plastic can break and send the sharp blade flying. I am not responsible for any injury that may occur from this design.

3d print tool blade blade holder bolt flat razor razor blade razor holder Razor Scraper scraper sharp Stanley 3d print tool blade blade holder bolt flat razor razor blade razor holder Razor Scraper scraper sharp Stanley

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer

FDM / FFF

File format