Thingiverse
Star IVO78
di KoenVdH
21
Download
26
Likes
0
Makes
12 point star similar to the star on the Sagrada Familia.
Center is a dodecahedron.
Peaks to be printed in Surface mode (using Cura).
10 x "peak"
2 x "peak with hole"
Peaks glued to each other using cyanoacrylate adhesive.
Base can be printed with the Lightning infill mode (using Cura).
E27 type of lamp, hole in the star is 41 mm, you need to find a lightbulb with a smaller diameter. I used a Philips Dimtone with the dome cut off.
Center is a dodecahedron.
Peaks to be printed in Surface mode (using Cura).
10 x "peak"
2 x "peak with hole"
Peaks glued to each other using cyanoacrylate adhesive.
Base can be printed with the Lightning infill mode (using Cura).
E27 type of lamp, hole in the star is 41 mm, you need to find a lightbulb with a smaller diameter. I used a Philips Dimtone with the dome cut off.
KoenVdH pubblica anche su
3 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!