Thingiverse
STAR VASE
von tomrib01
7
Downloads
14
Likes
0
Makes
Hi! This is a design of a vase I made using solidworks. I HOPE YOU LIKE IT! let me know your results!
Notes:
I sliced this in cura with spiralize outer contour enabled. I didn't like the original size I made so I scalled it to 110% on Z and 121% on Y. It looked very good at a 0.2mm layer height and with a wall line width of 0.8 (0.4mm extruder) . I printed it with only 4 bottom layers (about 0,8mm thickness), which was not very smart. Unfortunately the bottom wasn't thick enough so it couldn't hold water inside, so you should add some more layers.
Notes:
I sliced this in cura with spiralize outer contour enabled. I didn't like the original size I made so I scalled it to 110% on Z and 121% on Y. It looked very good at a 0.2mm layer height and with a wall line width of 0.8 (0.4mm extruder) . I printed it with only 4 bottom layers (about 0,8mm thickness), which was not very smart. Unfortunately the bottom wasn't thick enough so it couldn't hold water inside, so you should add some more layers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
