Thingiverse
Star Wars Night Light
von anonymoususer42
13
Downloads
10
Likes
0
Makes
This is yet another night light. Print as uploaded.
I used Prusa's ColorPrint feature for the front panel. The switch is at 0.60mm
I'd recommend using 3 or more perimeters if you don't want the light to show through the sides. The night light I use is a simple $2(US) one available at my local grocery store
Printed at 0.20 layer height, 2 perimeters, 20% infill
Once you have the night light base inserted into the cover, add a small amount of glue to hold the cap in place. (DON'T use a lot in case you need to change the bulb later)
I used Prusa's ColorPrint feature for the front panel. The switch is at 0.60mm
I'd recommend using 3 or more perimeters if you don't want the light to show through the sides. The night light I use is a simple $2(US) one available at my local grocery store
Printed at 0.20 layer height, 2 perimeters, 20% infill
Once you have the night light base inserted into the cover, add a small amount of glue to hold the cap in place. (DON'T use a lot in case you need to change the bulb later)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
