Thingiverse
Starbug
door wjordan819
36
Downloads
30
Likes
0
Makes
I Know there are a lot of Starbug models online, but when I looked at them all the STLs available where all grouped meaning if one part goes wrong of gets damaged you have to reprint the entire model.
My only option was to create my own and here is the result.
I know there is going to be some detail missing, the thin rods on the legs for instance. This has been done deliberately to enable easier printing and assembly.
I used an infill of 20% on the body and 100% on the smaller parts.
My only option was to create my own and here is the result.
I know there is going to be some detail missing, the thin rods on the legs for instance. This has been done deliberately to enable easier printing and assembly.
I used an infill of 20% on the body and 100% on the smaller parts.
wjordan819 publiceert ook op
13 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
