Starlink Internet House entry

This is a "weather proof" entry for the Starlink Dishy McFlatface internet cable. It has a large ferrite core on the power block end so requires a much larger hole than what is needed to accommodate the cable itself. This helps clean up the install. Based off of a 1" hole. I used a spade bit. Either an M3 nut and bolt can be used or a self tapping screw to keep the cap on, there is a cavity to accommodate an M3 nut within the base piece. You would need to pause, place nut, and resume the print in order to use the nut/bolt. Also if you would like the bicolor logo you would also need to do a pause/fliament swap for that. Both are optional but makes for a nicer end result I feel.