Thingiverse
Starwars Rebels Comlink
von saberart998
2
Downloads
5
Likes
0
Makes
this nifty thing doesn't need epoxy, it is kept in with friction might be a snug fit but it will be fine. You can just print in film if u would like, or as an alternative get rid of the Pegs by placing them under the build plate on your slicing software :). hope this goes well with your cosplay or display.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
