Thingiverse
#StayAtHome Roller
von owenlab
2
Downloads
0
Likes
0
Makes
Quarantine has converted almost all of us into pastry chefs and bakers, so I decided todesign a Roller pin with the #stayhome logo.
Is possible to change the lenght of the roller just scaling the roller in Z
Inside it need a M8 treathed rod, this version needs a 30cm one.
I printed it with TreeD Filaments Shogun PLA because it resist at 80% so I can clean it with a sponge soaked in hot water.
Is possible to change the lenght of the roller just scaling the roller in Z
Inside it need a M8 treathed rod, this version needs a 30cm one.
I printed it with TreeD Filaments Shogun PLA because it resist at 80% so I can clean it with a sponge soaked in hot water.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
