STC-1000 Case - low material version

This is an enclosure for the popular STC-1000 heat/cool module. It is very much inspired by thing:215383, but requires only about 50% of the material.

If you use the high voltage (110/220V) version of the STC-1000 controller, please make sure you know what you're doing: Use proper wire nuts, crimped wire ferrules and correctly rated wires. Also, don't electrocute yourself.


Required Material:
====================
- ~50 g filament
- 6x 3x12 mm wood screws (any length between 8 and 15 mm should work)

Required Material for the Wiring:
====================
- 3-way or 4-way wire nuts or Wago connectors (if you use jumbo sized connectors, the space inside the case might not be sufficient)
- wire ferrules and some properly rated wire
- 6x small zip ties



Instructions:
====================
1. Print bottom.stl and top.stl.
2. Thread cables through the holes of the "top" part. Secure the cables in place using zip ties.
3. Insert STC-1000 ~ 1/3 of the way and put retain