Thingiverse
StealthBurner - strain relief
von tomi992
9
Downloads
6
Likes
0
Makes
Strain relief for StealthBurner printhead.
Compared to original design, this one is supposed to be used without wire chain.
Wires to be secured by 2x zip ties at back of printhead.
Zip tie width: 2.5mm
Designed to be used with M3x5x4 (IDxODxL) heatserts (same as Voron).
Compared to original design, this one is supposed to be used without wire chain.
Wires to be secured by 2x zip ties at back of printhead.
Zip tie width: 2.5mm
Designed to be used with M3x5x4 (IDxODxL) heatserts (same as Voron).
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
