Steam Deck Charging Case

A case for the Steam Deck that contains a passthrough to allow for charging while in the case. Meant to be used with my Steam Deck Charge Port Support model. Required Parts:2x M4x30 Socket Head Screws2x M4 Threaded Inserts8x M4 WashersCA Glue or any type of super glue that works with your printed materialAssembly Instructions:1. Print All Build Plates 2. Install Skeletons2a. The top and bottom shells are held together by the skeleton frameworks you printed. These frameworks are glued into place using the notches that exist in the interior of the top and bottom shells. You may need to use a hammer to get the skeleton to go in all the way. I intentionally made this a very tight fit since it is a key structural element. 3. Install the Hinges3a. Each hinge uses an M4x30 Socked Head Screw and an M4 threaded insert.3b. First install the threaded insert on the hinge hole facing inward on both sides of the top shell.3c. Run the M4x30 from the outside hinge hole, through the bottom hinge hole,