Steam Desk Charging Cable Mount

I've been using the super handy Steam Deck mount from Tom here: https://makerworld.com/en/models/1290521-steam-desk-an-under-desk-steam-deck-mount#profileId-1320724 and been loving it. My biggest annoyance is the challenge of charging it and sliding it in and managing the charging cable. So I decided to design a mount to hold the FACTORY charging cable firmly in place while still allowing it to be removed and replaced if needed for travel. You can slide the steam deck into the holder as normal and once it touches the USBC cable end, a gentle push easily slides the cable in and starts charging. To remove I like to reach back and put a finger on either side of the cable and gently pull straight out. The cable has 3 diameters so install as described below:Slide the skinniest part of the cable through the side side slot, near the end of the plugGently PUSH the cable from the front into the hole towards the rear until it starts to get snugFinally pinch the rear of the mount and front po