Steampunk window lamp for E27

Steampunk lamp for hanging in a window or such.
Use with E27.

The hole is 40.5mm, which fits the E27 socket I used.
Overall height is about 23cm. Diameter is 15cm.
Biggest part is 210mm. It should fit a 200x200mm bed diagonaly.

Print minimum this many parts:
1 lamp_holder_bottom.stl
1 lamp_holder_top.stl
1 ring_bottom.stl
1 ring_middle.stl
4 sides.stl

You could print more than 1 ring_middle.stl if you like a different style.
Print as many screws and bolts as you like, to decorate with.

I used CA glue with activator to assemble.

This is how I glued it together:
Start with ring_bottom and glue the sides to it. Those two flat surfaces should make it fairly easy to get the sides straight enough. Then add the ring_middle. Remember to insert all middle rings before you glue them. Glue one side of the middle ring. Then measure distance from bottom and glue the opposite side at the same height. Then glue the remaining sides on the middle ring. Finish with the top parts