Thingiverse
SteelSeries Arctis 7 Headset Receiver Box
von Th3An0maly
6
Downloads
5
Likes
0
Makes
A slide-lid box to hold your SteelSeries Arctis 7 Headset receiver and power cable! The receiver can remain in the circular housing, and the USB cable can be connected to your computer or stored in the box. Also has room to store the USB cable for charging.
Layer Height: 0.2 mm
Supports: No
Build Plate Adhesion: None
Note: The slide-lid gap at the top of the box will string a bit and need some clipping (I used an X-Acto knife) and sanding. Perhaps supports would be useful here, but I didn't add any. I did allow for 0.3mm of tolerance in the gaps, but the lid still stuck a little. I added a thin layer of lubricant to the edges of the lid, and now it slides beautifully!
Layer Height: 0.2 mm
Supports: No
Build Plate Adhesion: None
Note: The slide-lid gap at the top of the box will string a bit and need some clipping (I used an X-Acto knife) and sanding. Perhaps supports would be useful here, but I didn't add any. I did allow for 0.3mm of tolerance in the gaps, but the lid still stuck a little. I added a thin layer of lubricant to the edges of the lid, and now it slides beautifully!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
