Steer Tube Cutting Guide

Saw guide for cutting 1-1/8" bicycle fork steer tubes. Can be clamped in a vise, insert the steer tube, tighten the top screw to hold it in place, and then cut with a hacksaw in the 2mm wide opening. Sized to accommodate carbon specific saw blades.

Also requires:
(2) M6 x 20mm bolts
(1) M6 x 35mm bolt
(3) M6 nuts

Assembly:
1. Attach the front and back using the M6 x 20mm bolts and two nuts.
2. Drop an M6 nut into the opening in the back piece.
3. Start to thread the M6 x 35mm bolt from the top through the nut.
4. Put the insert in place, drop the retainer into the opening on the insert.
5. Use a flat blade screwdriver to prevent the retainer from rotating.
6. Finish threading the M6 x 35mm bolt into the retainer.