Thingiverse
Stefano Knife prop - Evil Within 2
door Hoxdolum
27
Downloads
26
Likes
0
Makes
A cosplay prop that i needed for upcoming Con
Total length of this knife is 36.5cm
still minor parts i need to adjust but will find time after for that /
Add supports inside the ends to avoid fitting issues.
Then just used superglue to Connect all the pieces together.
Printed in PLA
Infill honeycomb at 25%
0.4mm / 0.2mm height
Average printing time in total 3 - 3.30Hours
For the smaller blade file , Seperate mesh/model as normal.
This was made for smaller /CTC printers bed sizes as the Full sized blade goes to 260mm.
As for the bottom hoop, One end is flat unlike the rest , This is the part to slot into the bottom of the handle.
Total length of this knife is 36.5cm
still minor parts i need to adjust but will find time after for that /
Add supports inside the ends to avoid fitting issues.
Then just used superglue to Connect all the pieces together.
Printed in PLA
Infill honeycomb at 25%
0.4mm / 0.2mm height
Average printing time in total 3 - 3.30Hours
For the smaller blade file , Seperate mesh/model as normal.
This was made for smaller /CTC printers bed sizes as the Full sized blade goes to 260mm.
As for the bottom hoop, One end is flat unlike the rest , This is the part to slot into the bottom of the handle.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
