Thingiverse
Engineering
Go to Model
Step Down DC Module Container
3
Downloads
6
Likes
0
Makes
I printed the LED Lightbars https://www.prusaprinters.org/prints/3267-led-light-bar-prusa-i3-mk2mk3 and I could not get 24v LED light strips , so could only get 12V for my MK3S+ which outputs 24v, so I needed a DC Step Down module.
And of course now I needed a little container to mount the converter.
So this container comes in 2 versions one with a slot so that you can adjust the height when mounting it to the back of the prusa printer and one without if you want to use this little container somewhere else.
This will fit a XL4015 or similar sized DC Step Down module
To mount the DC Step Down module
you can print the required standoffs from my page - https://www.prusaprinters.org/prints/131757-m2-pcb-standoffs
What you will need extra:
4x M3x16 Counter sunk screws (can be shorter but a minimum of 5mm in length required) - used to fasten the lid
2x M3x8r screws screws - this is to fasten the box to the Prusa Frame – this is Optional
And of course now I needed a little container to mount the converter.
So this container comes in 2 versions one with a slot so that you can adjust the height when mounting it to the back of the prusa printer and one without if you want to use this little container somewhere else.
This will fit a XL4015 or similar sized DC Step Down module
To mount the DC Step Down module
you can print the required standoffs from my page - https://www.prusaprinters.org/prints/131757-m2-pcb-standoffs
What you will need extra:
4x M3x16 Counter sunk screws (can be shorter but a minimum of 5mm in length required) - used to fasten the lid
2x M3x8r screws screws - this is to fasten the box to the Prusa Frame – this is Optional
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
