Step-Ladder Foot #2

Needed a replacement for 1 foot of my small step ladder, so I designed and printed it. Not sure if the measurements and angles are the same for other step ladders, too, but I still share it here. If you try them out, you may sand the bottom a bit with a rough sand-paper, to get more grip on the ground.

I just expanded the corner blocks a bit after printing it out, since I recognized that it was the weakest point.

Another Ladder-Foot I have designed is here:
https://www.thingiverse.com/thing:5417538

Small tip: Using ladder foots where the holding mount is inside the ladder strut like the one i linked seem more reliable.