Stepper Wheel - 28BYJ-48

I wanted a wheel on a 28BYJ-48 stepper motor with a rubberised tyre, so I designed this wheel and additional files to create the tyre with.

I've found that adding a true rubberised tyre with 3d printing (and therefore quickly prototyped) is actually difficult to reproduce, however while chatting to a friend about this I had a brainwave (thanks Mark :) ).
Hot Glue!

Hot glue, (when cooled) is extremely rubberised, its general friction coefficient range is really quite similar to rubber, and it's extremely easy and quick to to use, all of this is perfect for rapid prototyping!

So, in this pack of files you will find the wheel itself and three other parts:
+ tyre maker - pin
+ tyre maker - base
+ tyre maker - wall

Strongly advise putting some covering on the inside of the wall to make removal easier (I had to file out a groove when I made mine and sacrifice the wall, and that was even with putting a layer of blue painters tape on the inside of the wall!).
Also ensure that