Thingiverse
Sterlitech Nut Wrench
door circleofowls
1
Downloads
0
Likes
0
Makes
This is a wrench for Sterlitech quick disconnect nuts, aka Fast-Lock Four-Arm Knobs, for those times when you need them more than finger tight.
I'd recommend 5 perimeters and 40% infill for a good strong part, just about any filament will work fine. No supports are needed.
I'd recommend 5 perimeters and 40% infill for a good strong part, just about any filament will work fine. No supports are needed.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
