Steyr Aug Semi Auto Only selector

Fire selector for an airsoft Steyr Aug. Should fit most brands.

Feel free to tinker with it: https://tinkercad.com/things/bch8VbKMS5i

The selector is essentially a 9.5 x 9.5 x 45.5mm rectangle, if your selector is roughly that size then this should fit perfectly-ish

I test printed it at 0.2mm with Touching Bed supports and 10% infill and it fits in my GFC aug. It may be a tight fit. Can be briefly sanded down/smoothed for an easier fitment.

10% infill should be plenty as this is a very small part. Takes about 8 minutes on my printer on a slower speed setting than normal.

Printing at 0.1 will provide a greater relief for the selector stop notches, at 0.2 it's a little bit vague.