Thingiverse
Stick-on Clip-In Sensor Mount
von Department_Nine
17
Downloads
28
Likes
0
Makes
This clip-in humidity sensor mount makes battery replacement quick and easy.
- Fix inside tubs with double sided tape &/or M3 screws (one in the middle or two on the sides).
- Hygrometer clips in and out of mount, leaving it in place.
- Alignment notch keeps display straight.
- Hygrometer can move in and out axially, allowing it to be mounted flush or over an offset/step.
- Prints quickly and without supports.
Here is a more reliable battery cover: https://www.thingiverse.com/thing:6682187
And some more mounts: https://www.thingiverse.com/thing:5379301
Check out more printer accessories from Department_Nine!
- Fix inside tubs with double sided tape &/or M3 screws (one in the middle or two on the sides).
- Hygrometer clips in and out of mount, leaving it in place.
- Alignment notch keeps display straight.
- Hygrometer can move in and out axially, allowing it to be mounted flush or over an offset/step.
- Prints quickly and without supports.
Here is a more reliable battery cover: https://www.thingiverse.com/thing:6682187
And some more mounts: https://www.thingiverse.com/thing:5379301
Check out more printer accessories from Department_Nine!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!