Thingiverse
Sticker support
door OpenPrint3D
4
Downloads
3
Likes
0
Makes
It is a design to stick 200mm x 105mm stickers without damaging your bike while remaining legible.
Be careful to properly print it out if you are using it on a bike.
Frequently check the integrity or movement of the structure to avoid an accident.
Use it at your own responsibility.
For personns of MONNAIE PLEINE law project, just center it, stick it and cut bords.
http://www.initiative-monnaie-pleine.ch/
Be careful to properly print it out if you are using it on a bike.
Frequently check the integrity or movement of the structure to avoid an accident.
Use it at your own responsibility.
For personns of MONNAIE PLEINE law project, just center it, stick it and cut bords.
http://www.initiative-monnaie-pleine.ch/
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
