Stitch from Lilo and Stich

Stich from Lilo and Stitch. This is a rework of an existing single color model for hand painting to a 6 color print using the Kobra 3/Max/S1 and 2 ACE units. Objects can be re-colored to print on a 4 color setup, and likewise, additional colors can be added for more detail. I printed with purge to infill on one object, and purge to supports. Would likely benefit from purge to infill on all objects which would allow you to reduce the purge setting on the printer. I hade purge settings on the printer set between 4-9 depending on where on the print was at (if you cannot babysit it, I would set it to maybe 8 or 9? Just guessing there) Be warned: there is a LOT of poop generated as there are (on this 6 color version) at least 3 color changes at almost every level up to the ears above the head (1400+ color changes). 3 Stitches seems to be the max that will fit on a Kobra 3 plate. You can duplicate to print more if you have the Kobra 3 Max, likewise you can also delete some if you only want to print one or 2. NOTE 1: I have the objects set to slightly below the plane of the print bed, so that they have a flat bottom side. If you don't want the bottom to be flat, you can raise up to the level of the print bed. Enjoy and happy printing! NOTE 2: You may get a error regarding non-manifold edges. You are safe to ignore this. If you try to correct it, it will remove all the colors and supports. Happy printing!