Thingiverse
STM32F407VE development board case
von grafalex
4
Downloads
8
Likes
0
Makes
This is a case to protect STM32F407VE development board. It respects all connectors as well as LEDs.
Printing:
- Print 2 case halves, each of 2 pieces (Cap + Body). Glue Cap to the Body (I used acethone for parts printed in ABS)
- Use few pieces of a transparent filament as a light guide for LEDs. You may want to glue light guides with a hot gun
- Install buttons. Button holes as well as buttons may need some sanding
- Screw board with the case with four M3x6 screws
[](https://www.buymeacoffee.com/grafalex)
Printing:
- Print 2 case halves, each of 2 pieces (Cap + Body). Glue Cap to the Body (I used acethone for parts printed in ABS)
- Use few pieces of a transparent filament as a light guide for LEDs. You may want to glue light guides with a hot gun
- Install buttons. Button holes as well as buttons may need some sanding
- Screw board with the case with four M3x6 screws
[](https://www.buymeacoffee.com/grafalex)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
