Thingiverse
STM32F469 Disco Mount
di ChuckMcM
3
Download
4
Likes
1
Makes
This is a holder/mounting bracket for the ST Micro STM32F469i-DISCO evaluation board. This board has an 800 x 480 LCD on it, a ST32F469 processor, 8MB of DRAM, 8MB of FLASH and various peripherals (even an Arduino shield plug. The board comes with some standoffs but they are not a good holder for it.
This holder will hold the board up with a 30 degree tilt for easy viewing of the LCD and it gives enough space below to put a shield on if you want, or to plug in some peripherals to the expansion connectors on the back.
The mounting holes are 2.5mm which is a good size for self tapping #4-40 machine screws. Depending on your printer's wall settings these may be a bit tight. I screw in the screws before mounting the board so that they are "pre-threaded" and then put the board on. Hold them so that they don't break if you need to put some twist force on the screws. If they are just way too tight you can open them up by .25mm
This holder will hold the board up with a 30 degree tilt for easy viewing of the LCD and it gives enough space below to put a shield on if you want, or to plug in some peripherals to the expansion connectors on the back.
The mounting holes are 2.5mm which is a good size for self tapping #4-40 machine screws. Depending on your printer's wall settings these may be a bit tight. I screw in the screws before mounting the board so that they are "pre-threaded" and then put the board on. Hold them so that they don't break if you need to put some twist force on the screws. If they are just way too tight you can open them up by .25mm
ChuckMcM pubblica anche su
23 modelli aggiuntivi su altre 1 piattaforme
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
