STONE WAREHOUSE HO SCALE

This HO scale (1/87th) STONE WAREHOUSE building is printed in one session for the main structure. No measuring, assembly or gluing necessary. Windows are printed with horizontal and vertical versions being glued (back-to-back) smooth side to smooth side for a nice clean look. Do not cut apart as they are pre-registered for each wall.

Depending on your printer, some components may require some minimum minor trimming. I exclusively print with PLA and have found that ordinary clear lacquer thinner (Nail polish remover) is a wonderful glue. Make a small test for yourself of two pieces of printed scrap PLA and give it a try. Let sit for 20 seconds and then try to break it apart. It leaves no residue and is applied with a small artist detail brush. I've been using lacquer thinner as a glue on stryene and PLA for years. No sloppy or messy glue to show when finished.

If you would like me to design a custom model for you contact me at:

[email protected].