Slicer Discord
Stonehenge – 3D printable model from MyMiniFactory MyMiniFactory
Scan the World

Stonehenge

0 Downloads
527 Likes
0 Makes
Go to Model
Stonehenge is a prehistoric monument in Wiltshire, England, 2 miles (3 km) west of Amesbury and 8 miles (13 km) north of Salisbury. It consists of a ring of standing stones, with each standing stone around 13 ft (4.1 metres) high, 6 ft 11 in (2.1 metres) wide and weighing around 25 tons. The stones are set within earthworks in the middle of the most dense complex of Neolithic and Bronze Age monuments in England, including several hundred burial mounds. Archaeologists believe it was constructed from 3000 BC to 2000 BC. The surrounding circular earth bank and ditch, which constitute the earliest phase of the monument, have been dated to about 3100 BC. Radiocarbon dating suggests that the first bluestones were raised between 2400 and 2200 BC, although they may have been at the site as early as 3000 BC. One of the most famous landmarks in the UK, Stonehenge is regarded as a British cultural icon. It has been a legally protected Scheduled Ancient Monument since 1882 when legislation to pr
Category
Scan the World
Source
MyMiniFactory
Published
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
Min. bed size
50 mm (Small)
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection