Stoopid Advance Magnetic Effector

STOOPID MAGNETIC EFFECTOR DIRECT DRIVE, with double magnet give more than double stickyness!!

ADV ver. give the effector have CANBUS-like capability.... but this system use USB for data transfer... so no hassle to setup in klipper firmware..
for the pcb board design you can find here: https://oshwlab.com/adi.meganlordbalor.megan/smart-effector-v1

first gen 0.1 put the stepper driver on top, and still need extra 2 wire power 24v +and-

second gen 1.1 use only usb cable (4wire) but the power wire cut off... +and-, left only data-/+ the power wire connected direcly to 24v, and with extra stepdown module drop to 5v to power microcontroller and fan. NOTE!: use 65W usb, because they usualy use thick wire on the power line... and put stepper motor driver on bottom, give posibility have some air from extruder heatsink fan...

ADV version use pcb for reinforce rigidity of the effector, result is more rigid than non ADV ver... you could use ADV ver but not using the electronic is good