Thingiverse
"Stop Light" Dipole Center
by WillyMakit
4
Downloads
1
Likes
0
Makes
I liked the wire dipole antenna centers that are on Thingiverse, but wanted one that would attach to my mast directly with PVC threads (1/2"). I also wanted something that would allow me to provide strain relief for the antenna wire connectors.
I used Silicone to cover the interior components against water intrusion, and then sealed the cover with superglue. I wasn't planning on opening it up after I built it.
(can't use the hashtag symbol or it messes up my sizes of bolts....)
Other parts necessary was:
number 6 x 1/2" pan head screws x 4
number 6 washers x8"
number 6 split washers x4"
number 6 nut x4"
SO-239 Panel connector
various 14 AWG wire (about 8-12")
14 awg ring type connectors x3
1/4" pan head bolt 1/2" x2
1/4" split washers x4
1/4" washers x8
1/4" wing nut x2
Some superglue
I used Silicone to cover the interior components against water intrusion, and then sealed the cover with superglue. I wasn't planning on opening it up after I built it.
(can't use the hashtag symbol or it messes up my sizes of bolts....)
Other parts necessary was:
number 6 x 1/2" pan head screws x 4
number 6 washers x8"
number 6 split washers x4"
number 6 nut x4"
SO-239 Panel connector
various 14 AWG wire (about 8-12")
14 awg ring type connectors x3
1/4" pan head bolt 1/2" x2
1/4" split washers x4
1/4" washers x8
1/4" wing nut x2
Some superglue
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
