Storage Barrel - Working lock (and Squid)

Lockable barrel with two choices of tops and a working lock. The Lock mechanism consists of 3 parts and is designed to be pretty foolproof to mess-up. It is however only plastic, so forcing it to hard might not be the best of ideas.

At the bottom of the barrel is a secret compartment.

Shouldn't be a problem to put together, I have also added some feet for the barrel, but they are optional.

The model is printable without supports except for "Lock Inner Ring". Apart from that, it is advisable to print the barrel top and bottom with rafts to prevent lifting of the corners.

Files that need multiples:

- None

Parts that need to be glued:

- Barrel Feet (These are optional)
- Hinge Pin End (depending on how tight it fits)
- Lock Hook
- Lock Back

If the Hinge pin doesn't fit then try sanding it down till it's a bit smoother, it needs to be a tight fit for the lid to be able to remain up, but it also shouldn't be completely forced in. Also, make sure u have the correct