Storage box for 1/4" screwdriver hex bits

Storage box for 1/4" hexagonal screw bits.
Print in place, no supports required.

### bichromatic
For bichromatic print on single extruder, I use this technique : https://www.youtube.com/watch?v=D7FiT5VqLSg

0) you might check the video to setup the z-hop or retraction (my printer does not seem to care about it though)
1) in cura, load both "drillbox - box-black-1.STL" and "drillbox - box-white-1.STL"
2) select both models, right-click and and merge
3) translate to x=0, y=0
4) right-click again on the model and "ungroup models"
5) delete black model and print the white one
6) Redo steps 1 to 5 , but delete white model this time.

7) then print "drillbox - inner-3.STL" .
8) just insert the inner parts inside the box. You may use some drop of glue to secure it in place.
print instructions for mono-chromatic version

### monochromatic
1) Just print "drillbox - box-1.STL" .
2) then print "drillbox - inner-3.STL"
3) just insert the inner parts inside the box.
You may use some drop of glue