Thingiverse
Storage Tray
von Vikt0r
1
Downloads
3
Likes
0
Makes
A tray I made for the peg board with command strips or magnetically on the back/side of my lathe.
The Outer Dimensions are 3.5" length x 3.5" H (lower height @ 2") x 3.236" width
Inner Dimensions are 3.264" length x 3.382" H (lower height @ 1.882") x 2.882" width
The back has 3 spaces for Neodymium Bar Magnets at 60x10x3mm or 2 places for command strips.
The Outer Dimensions are 3.5" length x 3.5" H (lower height @ 2") x 3.236" width
Inner Dimensions are 3.264" length x 3.382" H (lower height @ 1.882") x 2.882" width
The back has 3 spaces for Neodymium Bar Magnets at 60x10x3mm or 2 places for command strips.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
