Thingiverse
Storage trolley kit!
door ModelWorld
0
Downloads
0
Likes
0
Makes
Storage trolley kit!
Please read if you do not know how to assemble it
The storage trolley has a lockable area, 3 non-lockable areas and wheels.
How to assemble:
Print off the trolley, using supports
Recycle the supports once you have cut them off, if you can!
Slide the axels into the loopy thingies, which are on the bottom of the trolley.
Use a strong glue to glue the loose disks on the other side of the axels, so they are symmetrical (look the same on both sides).
Slide the box with the loop into the gap, which is at the rooved storage area. It should have the small loop connected on top of the sheltered are next to it. (Use the diagram to help)
Tie sting onto the loop, which is located at the front of the trolley. (The *not* sheltered place)
The pole thing goes in the last loop, and should have the wider bit at the top.
Does it even make sense 😭???????
Please read if you do not know how to assemble it
The storage trolley has a lockable area, 3 non-lockable areas and wheels.
How to assemble:
Print off the trolley, using supports
Recycle the supports once you have cut them off, if you can!
Slide the axels into the loopy thingies, which are on the bottom of the trolley.
Use a strong glue to glue the loose disks on the other side of the axels, so they are symmetrical (look the same on both sides).
Slide the box with the loop into the gap, which is at the rooved storage area. It should have the small loop connected on top of the sheltered are next to it. (Use the diagram to help)
Tie sting onto the loop, which is located at the front of the trolley. (The *not* sheltered place)
The pole thing goes in the last loop, and should have the wider bit at the top.
Does it even make sense 😭???????
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
