Stormtrooper Bookmark - Hueforge

This is printed at 0.04 layer height. Please adjust your extruder setting to enable printing at this layer height. See below. If you do not have an AMS, just delete the filament changes and replace them with pauses instead. Then you can change filament manually when it pauses at the correct layer. If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please. Important:You CANNOT adjust the Z axis scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though.To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer.Please ensure your filament