Stormtrooper dad HueForge

Picture source - author: Brett Voutier @brettvoutierThen used HueForge v0.8.1 to create the model. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.The model size is 150x200 mm. You can only modify the X and Y dimensions. Do not adjust the height (Z) in your slicer! The layers would not be correct. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2.0mm and the Actual Depth is 2.0mm. It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support. Filaments Used: PLA Elegoo + Black Transmission Distance: 0.3 PLA BambuLab Basic Blue Gray Transmission Distance: 3 PLA Elegoo + Gray Transmission Distance: 3 PLA Elegoo + White Transmission Distance: 6This print uses 4 unique filaments Swap Instructions: Start with Black At layer #10 (0.88mm) swap to Blue Gray At layer #12 (1.04mm) swap to Gray At layer #14 (1.2mm) swap to White fo