Thingiverse
str1KER V2
von J99works
39
Downloads
23
Likes
0
Makes
- str1KER V2
- More durable
- Added straight supports version
- Added thin version - 4.5mm arms thickness instead of 6mm
- On pictures printed with Nylon - 0.2mm layer + 265° + fans off + speed 50mm/s + 100% infill = UNBREAKABLE FRAME !
- str1KER V2 - My most durable 3D printed frame !
- Best to print with #1 NYLON, #2 PETG #3 ABS (if you print it with nylon, it will be really unbreakable, petg holds up pretty well too)
- Very durable and light frame !
- Compatible with 110x motors, 20x20mm stack, wide fpv camera (up to 19mm wide)
- Clover antenna protection
- Lens protection
- You need 6x (M24 - M26) and 4x (M28 - M210) screws to put frame together ( - Means up to )
- To mount motors you need 8x (MAX 16x) M2*6 screws
- To mount FC you need 3mm or thinner screws
- Bottom plate is 2.8mm thick
- Arms are 6mm thick
- ends of arms - motor mounts are 3.2mm
- H version - h1TTER : https://www.thingiverse.com/thing:2779998
- Flat arms - r1PPER :https://www.thingiver
- More durable
- Added straight supports version
- Added thin version - 4.5mm arms thickness instead of 6mm
- On pictures printed with Nylon - 0.2mm layer + 265° + fans off + speed 50mm/s + 100% infill = UNBREAKABLE FRAME !
- str1KER V2 - My most durable 3D printed frame !
- Best to print with #1 NYLON, #2 PETG #3 ABS (if you print it with nylon, it will be really unbreakable, petg holds up pretty well too)
- Very durable and light frame !
- Compatible with 110x motors, 20x20mm stack, wide fpv camera (up to 19mm wide)
- Clover antenna protection
- Lens protection
- You need 6x (M24 - M26) and 4x (M28 - M210) screws to put frame together ( - Means up to )
- To mount motors you need 8x (MAX 16x) M2*6 screws
- To mount FC you need 3mm or thinner screws
- Bottom plate is 2.8mm thick
- Arms are 6mm thick
- ends of arms - motor mounts are 3.2mm
- H version - h1TTER : https://www.thingiverse.com/thing:2779998
- Flat arms - r1PPER :https://www.thingiver
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
