Strain Relief HBP Cable

Had an interesting problem. Details of problem and solution at: http://wiki.makerbot.com/forum/t-398964/hbp-weird-problem

The Problem: During builds, the individual wires of the HBP cable are flexed at the point of entry into the pin contact. This causes fatigue and, eventually, failure.

The Symptoms: Your HBP works erratically or not at all. Your control panel may report a HBP temperature of 1024 (this is a built-in error code).

The Fix: Solder your contacts (beyond the scope of this part, may not be necessary if you haven't yet fatigued your wires), install a strain relief (instructions below). Fast and easy to install, fast and easy to remove! This part holds your wires very firmly!

What I Need from You:
- I had started my MkB with the ABP, but quickly moved to HBP as the belt started wearing pretty quickly and I just don't want to deal with that. I strongly suspect that this part is compatible with the ABP, but I'm not sure. Could someone check this out?
- I al