Thingiverse
strand_beest
von yamamotoyossy
3
Downloads
1
Likes
0
Makes
strand_beest.
This is prototype.
Use Retaining Rings - E Type
-Comment-
It's 3D print test.
・Clearance-shaft and hole.
・Gear's backlash.
・check link ratio (https://en.wikipedia.org/wiki/Jansen%27s_linkage).
・Can I use E-ring(clip)? (Can I print E-ring? -It wasn't a good result.)
Now It is fidget.
Next try : I want to move beest by motor.
This is prototype.
Use Retaining Rings - E Type
-Comment-
It's 3D print test.
・Clearance-shaft and hole.
・Gear's backlash.
・check link ratio (https://en.wikipedia.org/wiki/Jansen%27s_linkage).
・Can I use E-ring(clip)? (Can I print E-ring? -It wasn't a good result.)
Now It is fidget.
Next try : I want to move beest by motor.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!