Thingiverse

Stratux ADS-B Casing

von Kevintjuh

49 Downloads

27 Likes

0 Makes

Hi All,

First I printed the Stratux Nano Dual SDR Case by Mistertech. (love the layout and concept of the case!)

Personally I missed a fan because the temperature in no-time raised above 70 degrees celcius, and also wanted a bit more space at the antenna cables.

So I used Siemens NX to re-draw Mistertech's design.

This case is a little bit higher to gain a bit more clearance for the fan, which is attached to the cover of the case.

Also I had a lacking and disturbed GPS signal, that's why I created a hole in the top shell (within the Stratux logo) right above the internal GPS unit.

To diminish the chance of magnetically disturbance from the LAN connector and Radio high gain antenna’s I have drawn an GPS shield, which I have covered up with copper tape, this is connected to by wire to one of the ground pins.

For the top of the case I tried “3DLAC spray adhesive” on the bedplate of the Ultimaker 3. Unfortunately I used a bit too much causing the top to look a bit dir

ADS-B aviation case casing flarm flying general aviation GPS GPS Shell raspberry pi case SDR Stratux ADS-B aviation case casing flarm flying general aviation GPS GPS Shell raspberry pi case SDR Stratux

Quelle

Thingiverse

Was du zum Drucken brauchst: Mittel Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 1/3

Drucker

FDM / FFF

Dateiformat