Slicer Discord
Strawberry, Flower, Spice Planter, Stackable – 3D-Druckmodell von Thingiverse Thingiverse

Strawberry, Flower, Spice Planter, Stackable

von PSomeone
125 Downloads
95 Likes
1 Makes
Zum Modell
Strawberry, Flower, Spice Planter, Stackable, with watering channels built in.

Print off as many planters as desired, Fill with good soil, plant strawberry's or other desired small plans in cups on the side. **(note these are small so you are limited by the roots.) Pour water in the dish on the top water will fill each dish as it over flows to the next level. This should provide an even water source for each level when you see it exit the bottom.

IDEA CREDIT - ROLFNILSEN

v.2 new opening to allow build without supports
more support for better build under water tray
added dish for under unitis
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Warum?
keine Supports
Ohne Supports Einteilig
Supports 0/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen